Here it is, before being dissected. Still working but with some issues.
Here is Dent # 1, Front Left Corner
Dent # 2, Back Left Corner, between the Display Bezel and the Top Case.
Here's a side view of Dent # 2, and Dent # 3. They are really the same dent, but due to Dent #2, the case had to be bent back with a screwdriver to allow the Power adapter clearance to plug in. Left side.
Here is Dent # 4, which will not be repaired. Top Display cover.
![]()
After putting the patient under, I begin surgery. These images may be graphic. Viewer discretion is advised, for exposed electronics and shocking imagery. (HA! Get it? Shocking... har har harrrr...)
Here she is, with the Top Case Cover Removed.
A closer view of the internal components, all intact, before removal.
Here is the Bottom Case, which all the other parts will be transplanted to.
A closer shot of the new Bottom Case.
The patient has been completely dissected, except for the Display Assembly, which by the way, Apple does not recommend for dismantling, even by Apple Certified Macintosh Technicians. They want us to replace that whole part. That's crazy talk! Muahahaha...
An overhead shot of my work bench, and most of the parts of our patient.
A close-up of the Logic board and Left I/O board
A close up of the Hard Drive, Super Drive, Airport/Bluetooth combo card, IR receiver, left and right blowers, and the left ambient light sensor.
What you don't see are the speaker assembly, the memory access door, battery, and a boat-load of tiny screws.
Remember that Display assembly that we aren't supposed to take apart?
![]()
It's apart.
Here's why Apple doesn't want it to be dismantled. The Red areas above, have epoxy on them. (Well, not my finger) The LCD Panel is literally glued to the bezel. That didn't seem to stop me. One damaged LCD panel removed, and at a far lesser cost than Apple would have asked.
After this point, I actually stopped taking pictures. However, the machine was reassembled, and is working properly. The LCD panel was replaced, the top case cover was replaced, and the bottom case was replaced. The original keyboard was attached to the new top case cover. All of the other original parts were transfered to the new bottom case.
The patient was revived, feeling like a cosmetically and functionally new machine. I even managed to bang out the small dent in the display backplate. While this didn't eliminate the dent, it made it significantly less noticeable.
Comments